Table of Contents
Advertisement
3
INSTALLATION
3-1 WALL MOUNTING
Remove the chassis from the back box.
1
2
Fix the chassis to the wall.
Wall mounting
screws
(M4×20, supplied)
After mounting the chassis, wiggle the tamper bushing
with your thumb and forefinger to ensure the tamper
works properly.
Insert the specified batteries into the back box.
3
Specified batteries
SAFT LSH20
3.6 V 13 Ah
• Do not use batteries other than those specified.
Specified batteries:
Four LSH20 batteries manufactured by SAFT
• Do not mix batteries that have different levels of
power remaining (i.e., new and used batteries).
Not observing the above may result in an explosion,
leakage of electrolyte, emission of toxic gases or
other outcomes that may be harmful to people and
property.
Remove all batteries prior to replacing with new ones.
If this is not followed, the low battery indicator LED will
not reset and continue to flicker.
Caution
Warning
Caution
Install the back box onto the chassis.
4
Tighten the
back box lock screw.
Complete the registration to the wireless receiver before
mounting the wireless transmitter EN1941 to AX-100TFRi/
200TFRi. If not completed, a step to press the reset button
is added to the registration procedure.
For more information, see "2-2 REGISTER WIRELESS
TRANSMITTER" on page 2.
-3-
Caution
Advertisement
Table of Contents
