Move The Disk Enclosure Onto The Lift Tool <= Ssr Task - IBM Power775 Service Procedure

3.10 Move the Disk Enclosure onto the Lift Tool <= SSR TASK
CAUTION:
DANGER:
can cause
severe injury or death. (L004)
CAUTION:
CAUTION:
(L009)
ATTENTION: The DE weighs about 550 lbs (250 kg) when full.
CAUTION:
ATTENTION: Small gaps exist that could pinch body parts if care is not exercised.
DANGER:
mishandled. (L013)
STEP 41 Ensure the DE will clear all cables.
Lift the DCCA cables that were connected to the DE out of the left raceway to create clearance for
the DE to slide out of the frame (see Figure 36). Make sure the DE, especially the corners, will
clear all cables.
Power775 Disk Enclosure Chassis Service Procedure
Do not remove or install this unit without using the provided lift tool. (C017)
Hazardous voltage present. Voltages present constitute a shock hazard, which
Sharp edges, corners, or joints nearby. (L006)
System or part is heavy. The label is accompanied by a specific weight range.
Pinch hazard. (L012)
Heavy equipment—personal injury or equipment damage might result if
Page 49 of 171