IBM Power775 Service Procedure page 154

29. Replace the inner cap into the white system water container insert.
Turn inner cap clockwise with a large screwdriver.
30. Place all hose assemblies and adapters in their appropriate locations within the FDT
storage enclosure.
31. Determine whether the FDT will be used for another procedure:
• If the FDT will be used for another procedure, leave tool activated and go to
that procedure now; skip the remaining steps of this procedure.
• If the FDT requires no further use - proceed to the next step.
32. Click the Deactivate FDT button.
• If the Deactivate FDT command is successful – OK. Proceed to next step.
• If the Deactivate FDT command fails– action required.
Repeat Deactivate FDT. If the Deactivate FDT command fails again,
contact next level of support.
33. Disconnect FDT UPIC power cable from port T10 of BPC used.
Wrap the UPIC cable in appropriate cable storage location on FDT.
34. If this procedure was referenced from another procedure, return to parent procedure.
Power775 Disk Enclosure Chassis Service Procedure
---- Appendix F: FDT Tank Fill Procedure ----
Page 154 of 171