Disk Drive Bezels and Fillers
The following procedures describe the removal and replacement of disk drive bezels. Before performing
the following procedures, read the "Safety Notices" on page v. Each disk drive slot in the system must
contain either a disk drive or the appropriate filler panel.
Removing a Disk Drive Bezel from a Disk Drive or Filler
To remove a disk drive bezel from a disk drive or filler, do the following:
1. Remove the filler panel from the disk drive slot, or follow the procedures for removing a disk drive
described in "Hot-Swap Disk Drives" on page 33.
2. Remove the disk drive bezel from the front of the filler panel or disk drive. See the following illustration.
3. Attach the disk drive bezel to the front edge of the filler panel or replacement disk drive.
4. Place the filler panel in the empty disk drive slot, or follow the procedures for adding a disk drive as
described in "Hot-Swap Disk Drives" on page 33.
1
1 Filler Panel, Upside Down with
Bezel Attached
2 Disk Drive Bezel Handle
Replacing or Installing a Disk Drive Bezel onto a Disk Drive
To replace or install a disk drive bezel onto a disk drive or filler, do the following:
1. Remove the disk drive filler panel from the slot you want to use by pressing the filler release tab
located at the top front edge of the filler panel and pulling the filler out of the system.
2. Remove the disk drive bezel plug from the front of the filler panel.
3. Remove the disk drive bezel from the front edge of the filler panel.
4. Attach the disk drive bezel to the front of the disk drive.
5. Follow the procedures for adding a disk drive as described in "Hot-Swap Disk Drives" on page 33.
1 Disk Drive Bezel
32
IntelliStation POWER 9114 Model 275 Parts Guide
2
2
5
3
4
3 Filler Panel Release Tab
4 Disk Drive Bezel
5 Disk Drive
1
2 Disk Drive
4
Need help?
Do you have a question about the IntelliStation POWER 9114 Model 275 and is the answer not in the manual?
Questions and answers