Install New De Into Frame <= Ssr Task - IBM Power775 Service Procedure

3.16 Install new DE into frame <= SSR Task
CAUTION:
DANGER:
can cause
severe injury or death. (L004)
STEP 67 Attention: Ensure that all the cables of the frame are clear so that the Lift Tool table will not
catch on cables as it is moved up and down across the face of the frame. Also ensure that the
UEPO Panel is still out of the way.
STEP 68 Using Battery powered drill shipped with the Lift Tool, 5/16 inch socket , ¼ inch drive adapter
P/N 39F8449, raise the Lift Tool table until the DE is lined up with the frame location that the
damaged DE removed from.
STEP 69 Align the DE channels with the DE rail rollers and applying force to the cable tray, slide the DE
back into the frame carefully. Be careful not to damage any cables.
ATTENTION: Do not push on any FRUs. Apply force only to the cable tray.
STEP 70 Install the two Rear Rail Block Captive Allen head screws (see Figure 26).
STEP 71 Lower the Lift Tool, detach it from the frame, and store it.
a. Retract the table extensions and stop plate extended in STEP 36 and STEP 37.
b. Detach the Lift Tool brackets that were installed in STEP 32. Be sure to completely
disengage brackets from frame before attempting to move Lift Tool.
c. Using the battery powered drill lower the Lift Tool table to its lowest most stable
position. Attention: Watch to ensure cables are clear during this operation!
d. Store the winch with Lift Tool for future use.
STEP 72 Using the procedure "Appendix C: Power775 DE Fill Procedure", fill the new DE Chassis. This
will require the Fill and Drain Tool P/N 45D6928.
STEP 73 Attach the water hoses by pushing the quick connects onto the DE water connectors.
Power775 Disk Enclosure Chassis Service Procedure
Do not remove or install this unit without using the provided lift tool. (C017)
Hazardous voltage present. Voltages present constitute a shock hazard, which
Page 68 of 171