IBM Power775 Service Procedure page 148

• Tank Level:
16. Locate a full system water container.
Transport the container to the location of the FDT.
Do not place the container between the FDT and the open frame.
NOTE: Use of a non-full system water container will result in repeated FDT filling
operations.
IBM PN 45D2124 (U.S.), 45D2129 (non-U.S.).
CAUTION:
The water-based coolant solution may contain an additive intended to inhibit
corrosion (or provide other functions). The solution may cause irritation to the skin or
eyes. Avoid direct contact with the solution. Employ appropriate Personal Protective
Equipment when performing operations involving the coolant or which may potentially
expose you to the coolant. Refer to the MSDS for more information. (C037)
CAUTION:
Protective eyewear is needed for the procedure. (L011)
CAUTION:
Chemical resistant gloves are needed for this procedure. (L014)
DANGER:
Risk of electric shock due to water or a water solution which is present in this
product. Avoid working on or near energized equipment with wet hands or when spilled
water is present. (L016)
The system water is treated and must not be poured down a sink or on the
ground.
Power775 Disk Enclosure Chassis Service Procedure
---- Appendix F: FDT Tank Fill Procedure ----
CRITICAL – click the Decode Error Status button, record the
information returned and contact next level of support.
Lower Half or Empty – OK.
Note tank level, and proceed to next step.
Upper Half or Full – FDT should not be filled.
Exit procedure.
Page 148 of 171