Table of Contents
Advertisement
4
The hand guard is correctly fitted when the spring
comes into the slot on the hand guard as shown in
Figure 5e.
5
Fasten screws A and B. Tightening torque 1-2 Nm.
See Figure 6.
8.3 Dismantling the throttle lockout,
throttle and spring
1
Dismantle the drive wheel cover, saw chain and bar.
Separate the crankcase.
Refer to "Basic dismantle/assembly".
2
Lift away the throttle lockout and throttle from their
fastenings in the handle and unhook the recoil
spring from its fastening in the throttle.
See figure 7.
Cleaning and inspection
• Clean and check all parts thoroughly. Parts must
be replaced if cracked or showing signs of other
defects. Always use original spare parts.
• Check that the recoil spring is intact and retains
all its tension.
See figure 8.
Fig 5e
Fig 6
Fig 7
Fig 8
Safety equipment
A
B
English –
21
Advertisement
Table of Contents
