Table of Contents
Advertisement
Repair Instructions
9.7 Assembling the trigger switch
S/N – 2015100001
1
Apply grease (588 17 64-01) to the trigger switch
and connector as shown in figure 1.
Plug connectors (A) and (B) into the trigger switch
and then place the sensor in the crankcase.
2
Apply grease (588 17 64-01) inside the connector
before assembly. See (A) figure 2.
Connect the cables.
See figure 3.
Apply grease on both sides of the connector as
shown in figure 2 (B).
3
Make sure the cables are held in place inside with
plastic clips so they are not pinched when the saw
is assembled. See figure 4.
4
Assemble the chain saw.
Refer to "Basic dismantle/assembly".
28 –
English
B
A
Fig 1
A
B
Fig 2
Fig 3
Fig 4
Advertisement
Table of Contents
