Table of Contents
Advertisement
10 Troubleshooting - T536 LiXP
Symptom
Product cannot be activated. No
LED´s light up when pressing the
on/off button.
Product cannot be activated and
destroys batteries that are inserted
Electric motor does not react when
applying the trigger
Electric motor jerks shortly when
applying the trigger, then stops
Product shuts off when applying
load
Keypad lights flicker
Unstable motor speed
Possible causes
Broken battery
Bad connection between battery and
product
Bad connection in keypad connector
Broken keypad
Damage to multiwire cable between
control unit and keypad/trigger switch
Broken control unit
Short circuit in control unit
Bad connection in trigger switch signal
connector
Motor connector not correctly assem-
bled
Internal damage to trigger switch
Short circuit in control unit
Short circuit in control unit
Bad connection between battery and
product
Bad connection in keypad connector
Short circuit in keypad
Bad connection in trigger switch signal
connector
Damaged or worn trigger switch
Troubleshooting
S/N – 2015100001
Recommended actions
1. Check battery by pressing the
status button. Minimum 1 green
LED should be visible. See also
Battery and Charger
2. Make sure power connectors
between battery and product are
not damaged and free from dirt.
See pic. 1 in appendix.
3. Make sure the keypad connec-
tor is properly assembled, dry, not
damaged and free from corrosion.
See pic. 2 in appendix.
4. Replace keypad
5. Repair/replace multiwire cable.
(Only if visible damage is present)
6. Replace control unit
Replace control unit
1. Make sure the trigger switch
signal connector is properly as-
sembled, dry, not damaged and
free from corrosion. See pic. 3 in
appendix
2. Make sure the motor
connector(s) are correctly assem-
bled. See pic. 4 in appendix.
3. Replace trigger switch
4. Replace control unit
Replace control unit
Make sure power connectors bet-
ween battery and product are not
damaged and free from dirt. See
pic. 1 in appendix.
1. Make sure the keypad connec-
tor is properly assembled, dry, not
damaged and free from corrosion.
See pic. 2 in appendix.
2. Replace keypad
1. Make sure the trigger switch
signal connector is properly as-
sembled, dry, not damaged and
free from corrosion. See pic. 3 in
appendix
2. Replace trigger switch
English –
45
Advertisement
Table of Contents
