Table of Contents
Advertisement
8.1 Dismantling the hand guard
1
Secure the saw with assembly fixture
502 51 02-01.
2
Dismantle the drive wheel cover, saw chain and
bar.
Refer to "Basic dismantle/assembly".
3
Release the brake by moving the hand guard back-
wards.
Note! It is essential this procedure is carried
out as it facilitates the assembly of the hand
guard.
Loosen screws (A and B) for the hand guard.
See figure 1.
4
Turn the hand guard horizontal so screw hole (B)
on the left-hand side passes its fastening on the
saw.
See figure 2
5
Continue turning the hand guard downward so its
heel (C) comes loose from the heel on the saw (D).
Take care not to damage the heels.
See figure 3
WARNING!
Exercise care to ensure the spring
inside (A) does not fly out and
cause personal injury. Wear protec-
tive goggles!
Cleaning and inspection
• Clean and check all parts thoroughly. Parts must
be replaced if cracked or showing signs of other
defects. Always use original spare parts.
• Check that the spring inside (A) is intact and re-
tains all its tension. Replace the spring if neces-
sary.
See figure 4.
8 Safety equipment
Fig 1
Fig 2
Fig 3
Fig 4
A
C
D
Safety equipment
B
B
19
English –
Advertisement
Table of Contents
