Table of Contents
Advertisement
9.6 Dismantling the trigger switch
S/N – 2015100001
1
Dismantle the drive wheel cover, saw chain and bar.
Separate the crankcase.
Refer to "Basic dismantle/assembly".
2
Unplug the connector from the keypad, carefully
loosen the connector from the self-adhesive tape
and put the connector and cable to one side.
See figure 1.
3
Remove the trigger switch and unplug connector
(A).
Take loose the connector (B) using a small screw-
driver to carefully free the heels (D) on each end of
the connector and main switch from each other.
NOTE! Do not pull the wires. Take special care to
avoid damaging the contact (B).
See figure 2.
Cleaning and inspection
Clean and check the trigger switch. The trigger
switch must always be replaced with a new one if
cracked or showing signs of other defects. Always
use original spare parts.
See figure 3.
Fig 1
C
C
Fig 2
Fig 3
Repair Instructions
A
B
27
English –
Advertisement
Table of Contents
