Repair Instructions
9.4 Dismantling the impeller
1
Dismantle the drive wheel cover, saw chain and bar.
Separate the crankcase.
Refer to "Basic dismantle/assembly".
NOTE! The impeller can be dismantled with the
motor assembled or dismantled.
2
Take the impeller off the motor.
See figure 1.
Cleaning and inspection
Clean and check the impeller. The impeller must
always be replaced with a new one if cracked or
showing signs of other defects. Always use original
spare parts.
See figure 2.
9.5 Assembling the impeller
1
Press the impeller onto the motor.
Make sure the motor shaft (A) protrudes 1.85 mm.
See figure 1.
2
Assemble the chain saw.
Refer to "Basic dismantle/assembly".
26 –
English
Fig 1
Fig 2
Fig 1
1,85 mm
A