Table of Contents
Advertisement
7 Basic dismantle/assembly
The steps described below are the basic steps that
must be carried out before any other service or
repair work or final assembly is possible.
7.1 Battery
Press in the catches and remove the battery.
See figure 1.
Replace the battery once assembly has been
completed.
WARNING!
The battery must always be removed
for service/repair work and may only
be replaced once the chain saw has
been completely
assembled again!
7.2 Drive wheel cover and bar
Release the brake by moving the hand guard back-
wards.
Remove the bar nut and the drive wheel cover,
saw chain and bar.
See figure 2.
Assemble in the reverse order.
7.3 Front hand guard
Refer to "dismantling front hand guard" in the
"Safety equipment" chapter
7.4 Separate the saw
Remove the screws (9x) and lift off the crankcase
half.
See figure 4.
Assemble in the reverse order.
Tightening torque 1.7 ~ 2 Nm.
NOTE! It should be easy to put together the
crankcase halves.
Make sure cables and such are positioned cor-
rectly if this is difficult.
1
2
Fig 1
Fig 2
Fig 3
Fig 4
Basic dismantle/assembly
1
A
B
English –
17
Advertisement
Table of Contents
