Repair Instructions
9.17 Assembling the chain brake
WARNING!
Exercise care to ensure the springs
do not fly out and causes personal
injury. Wear protective goggles!
1
Lubricate as instructed in "Service Data".
2
Place the spring and shaft (B) with the heel in its
groove on the crankcase followed by the catch (C).
See figure 1.
3
Compress the large spring (A) and place it in its
groove.
See figure 2.
4
Refit the cover and screws (3x).
Tightening torque 1 Nm.
See figure 3.
5
Plug in the connectors, replace the cables and
fasten the connector for the chain brake sensor to
its attachment.
6
Fit the motor
See "Assembling the motor"
7
Assemble the saw.
Refer to "Basic dismantle/assembly"
38 –
English
Fig 1
A
Fig 2
Fig 3
B
C