Table of Contents
Advertisement
Safety equipment
8.4 Assembling the throttle lock,
throttle control and spring
1
Hook the recoil spring again onto the throttle.
Assemble the throttle and throttle lockout on their
respective attachments on the handle. Make sure
the hooks are inside the handle. Place the recoil
spring in the throttle lockout.
See figure 9.
2
Assemble the saw.
Refer to "Basic dismantle/assembly".
8.5 Replacing the chain catcher
Always replace a worn chain catcher with a new
one.
1
Dismantle the drive wheel cover, saw chain and
bar.
Refer to "Basic dismantle/assembly".
2
Remove the screw and replace the chain catcher.
Tightening torque 2.5 ~ 3 Nm.
See figure 10.
8.6 Replacing the spike bumper
Always replace a worn spike bumper with a new
one.
1
Dismantle the drive wheel cover, saw chain and
bar.
Refer to "Basic dismantle/assembly".
2
Remove the screws (2x) and replace the spike
bumper.
Tightening torque 2.5 ~ 3 Nm.
See figure 11.
8.7 Replacing the belt hook and rope
eye
Always replace a damaged hook/eye with a new
one.
Remove the screw holding the hook/eye. Replace
the parts.
Tightening torque 2.5 ~ 3.5 Nm.
See figure 12.
22 –
English
Fig 9
Fig 10
Fig 11
Fig 12
Advertisement
Table of Contents
