Table of Contents
Advertisement
9.10 Dismantling the control unit
S/N – 2015100001
NOTE!
Note how wires, components, etc., are posi-
tioned before dismantling.
Make sure to position them correctly to
avoid pinching when the chain saw is reas-
sembled.
1
Dismantle the drive wheel cover, saw chain and bar.
Separate the crankcase.
Refer to "Basic dismantle/assembly".
2
Dismantle the motor.
See "Dismantling the motor".
3
Disconnect the contact from the keypad.
See "Dismantling the keypad".
4
Remove the main switch and unplug the connectors.
See "Dismantling the main switch".
5
Unplug the connector for the chain brake sensor (A).
See figure 1.
6
Remove cable retainer (B) and unscrew cable re-
tainer (C)
See figur.e 2.
7
Remove the screws E and D.
Remove the control unit and battery connector.
See figure 3.
Cleaning and inspection
Clean and inspect all parts of the control unit. The
control unit must always be replaced with a new
one if cracked or showing signs of other defects.
Always use original spare parts.
See figure 4.
A
Fig 1
C
B
Fig 2
D
Fig 3
Fig 4
Repair Instructions
E
E
D
31
English –
Advertisement
Table of Contents
