Safety equipment
6.10 Dismantling the throttle lock, throttle
control and spring
1
Dismantle the rear handle screws (3) and loosen
the handle half. See figure 18.
2
Loosen the throttle lockout from the handle and
then dismantle the spring and throttle.
See figure 19.
Cleaning and inspection
•
Carefully clean and check all parts. See figure 20.
Parts must be replaced if cracked or showing
signs of other defects. Always use original spare
parts.
•
Check that the spring is intact and retains all its
tension.
21 –
English
Fig 18
Fig 19
Fig 20