Safety equipment
6.11 Dismantling the throttle control
lock, throttle control and spring
1.
Loosen the screw on the rear handle. Remove
the handle insert (A). See figure 19.
2.
Loosen the throttle control lock (B) as shown in
the figure using a screwdriver or similar tool.
Remove it then from the shaft in the handle.
See figure 20.
3.
Press out the throttle control pin (C) with the
help of a punch. See figure 21.
4.
Loosen the throttle cable (D) and lift out the
throttle control and the spring. See figure 22.
6.12 Cleaning and inspection
• Carefully clean and check all parts. See figure 13.
Parts must be replaced if cracked or show signs
of other defects. Always use original spare parts.
• Check that the spring is intact and retains all its
tension.
17
- English
A
Fig 19
Fig 20
Fig 21
Fig 22
Fig 23