Table of Contents
Advertisement
9.18 Dismantling the chain brake sensor
1
Dismantle the drive wheel cover, saw chain and bar.
Separate the crankcase.
Refer to "Basic dismantle/assembly".
2
Unplug the connector (A).
See figure 1.
3
Dismantle the chain brake.
See "Dismantling the chain brake".
4
Remove the sensor.
See figure 2.
Cleaning and inspection
Clean and check the sensor. The sensor must
always be replaced with a new one if cracked or
showing signs of other defects. Always use original
spare parts.
See figure 3.
9.19 Assembling the chain brake sensor
1
Place the sensor in the crankcase.
See figure 1.
2
Assemble the chain brake.
See "Assembling the chain brake".
3
Plug in connector (A) and place it in its attachment
on the chain brake cover.
See figure 2.
4
Assemble the saw.
Refer to "Basic dismantle/assembly".
A
Fig 1
Fig 2
Fig 3
Fig 1
A
Fig 2
Repair Instructions
39
English –
Advertisement
Table of Contents
