9 Throttle trigger lockout, throttle trigger and spring
9.1 Dismantling
1.
Remove the bar, chain and cylinder cover.
2.
Loosen the screw to the vibration damping unit on
the starter side. See figure 1.
3.
Unscrew the screw on the rear handle (A) and
remove the handle insert (B). See figure 2.
4.
Press out the throttle trigger pin (C) using a punch.
See figure 2.
5.
Remove the throttle trigger lockout (A) using a
screwdriver or similar tool. Lift it upwards from the
shaft in the handle. See figure 3.
6.
Loosen the throttle cable in the carburettor (D). See
figure 4.
7.
Lift out the throttle trigger and the spring. See
figure 3.
8.
Unhook the throttle cable (A) from the cut-out in the
throttle trigger. See figure 9.
9.2 Cleaning and inspection
•
Carefully clean and inspect all parts. See figure 5.
Parts must be replaced if cracked or if they show
signs of other defects. Always use original spare
parts.
•
Check that the spring is intact and retains all its
tension.
Throttle trigger lockout, throttle trigger and spring
Fig. 1
A
Fig. 2
Fig. 3
D
Fig. 4
Fig. 5
A
B
C
A
A
B
English - 19