Husqvarna T536 Li XP Workshop Manual page 30

Repair Instructions
9.9 Assembling the trigger switch
S/N 201510000 –
1
To prevent corrosion on the trigger switch connec-
tor, place two dots of grease (588 17 64-01) on the
pins before assembly. See figure 1.
2
Connect the wires to the trigger switch.
3
Place two dots of grease as close as possible to
the connector on the yellow wires. See figure 2.
4
Place the trigger switch in the crankcase.
See figure 3.
5
Attach the keypad connector to the trigger switch.
See figure 4.
6
Assemble the chain saw.
Refer to "Basic dismantle/assembly".
30 –
English
Fig 1
Fig 2
Fig 3
Fig 4