BIRD Digital Power Meter Display Operation Manual page 70

Digital Power Meter Display, 5000-NG
Forward DAC Gain —
VDC representing the full scale of the forward power. The Forward
setting allows the adjustment of the value the voltage represents. This allows for
increased resolution at lower power levels.
1 - 5 VDC = Full Power
2 - 5 VDC = 1/2 Full Power
4 - 5 VDC = 1/4 Full Power
8 - 5 VDC = 1/8 Full Power
Note: If the full scale of the ACMI is 2.5 W to 100 W.
If 1 is selected for the
equivalent of 100 W.
If 2 is selected for the
of 50 W.
Reflected DAC Gain —
VDC representing the full scale of the reflected power. The Reflected
setting allows the adjustment of the value the voltage represents. This allows for
increased resolution at lower power levels.
1 - 5 VDC = Full Power
2 - 5 VDC = 1/2 Full Power
4 - 5 VDC = 1/4 Full Power
8 - 5 VDC = 1/8 Full Power
Note: If the reflected full scale of the ACMI is 250 mW to 10 W.
If 1 is selected for the
equivalent of 10 W.
If 2 is selected for the
of 5 W.
Alarm Latch Enable —
When disabled alarms will automatically reset after approximately 40 seconds.
VSWR Alarm on Zero Enable —
power (less than 2.5% of full scale) due to noise floor the sensor. When
disabled,VSWR is NOT monitored at very low power levels (less than 2.5% of full
scale).
Power Up Alarm Enable —
condition on power on until first power measurements are made. When
disabled, ACMI will not set an alarm at power on.
61
The ACMI has an linear analog output voltage of 0-5
DAC Gain the 5 VDC output would be the
DAC Gain the 5 VDC output would be equivalent
The ACMI has an linear analog output voltage of 0-5
DAC Gain the 5 VDC output would be the
DAC Gain the 5 VDC output would be equivalent
When enabled, alarms must be manually reset.
When enabled,
When enabled, the ACMI will be in alarm
DAC
DAC
VSWR will alarm at low
Gain
Gain