Measurement Procedure; Acmi Configuration Menu Options - BIRD Digital Power Meter Display Operation Manual

Measurement procedure

The only configuration options for the ACMI are for alarms, relay control, and
analog outputs for forward and reflected power. See
Menu Options" on page 60
Reset Alarm option is available under Device Actions on the Sensor Operation
Menu
Alarms can be reset on the Functions Menu.

ACMI Configuration Menu Options

Alarm Sense —
condition occurs. This setting should match the relay electrical output
NC) selected for ACMI relay interfacing equipment.
Options are Enabled and Disabled.
Alarm Enable —
signal conditions exceed alarm settings.
Options are Enabled and Disabled.
VSWR Trip Point —
through 2.5.
An alarm is triggered when:

If VSWR
power is monitored for trend.
If reflected power is increasing an alarm is triggered.
If reflected power is not increasing, and
VSWR

If VSWR
immediately.
Low Power Alarm Enable —
Enable<XREF> are enabled, alarms will be reported whenever signal conditions
fall below alarm settings.
Options are Enabled and Disabled.
Low Power Alarm Level —
alarm. Enter the low power level for the alarm then select the unit associated
with the value.
High Power Alarm Enable —
Enable<XREF> are enabled, alarms will be reported whenever signal conditions
exceed alarm settings.
Options are Enabled and Disabled.
High Power Alarm Level —
alarm. Enter the high power level for the alarm then select the unit associated
with the value.
.
Alarm Sense sets the relay state
When Enable is selected, alarms will be reported whenever
Selectable set point for
is equal to or slightly higher than the trip point, reflected
exceeds trip point for 30 seconds an alarm is triggered.
is much greater than the trip point an alarm is triggered
When Low Power Alarm AND
Setting for the trip point for the low power
Setting for the trip point for the high power
VSWR
When High Power Alarm AND
"ACMI Configuration
(NO or NC) when an alarm
alarm, Settings are 1.3
Alarm
Alarm
(NO or
60