Hisense Covidien HME2C26 User Manual page 7

EMC Statement
All electronic devices may generate electromagnetic interference to other devices through air or cables
connected with them. Electromagnetic compatibility (EMC) refers to the capability of a device not to
be affected by electromagnetic interference of other devices and not to affect other devices by similar
electromagnetic radiation.
To fully achieve the specified EMC performance, users should follow the detailed instructions in the
service manual to properly install this product.
Warning: Do not use this device when other devices are adjacent or stacked together;
otherwise, it may lead to improper operation. When necessary, observe this device and
other devices to confirm that they can operate normally.
Warning: The use of accessories, sensors, and cables not specified or provided by the
manufacturer of this device may lead to increased electromagnetic radiation or decreased
electromagnetic immunity, and improper operation.
Warning: Portable RF communication devices (including peripheral devices such as
antenna cables and external antennas) should be used at least 30 cm (12 inches) away
from any part of Hisense LCD, including cables specified by the manufacturer.
Otherwise, the monitor performance may be degraded.
Caution: The manufacturer is not responsible for any interference or response caused by
using non-recommended interconnection cables or making changing or modifying this
device without authorization. Unauthorized changes or modifications may deprive users
of the right to operate the device.
Caution: Unless this device is provided by Hisense, it is best not to operate devices that
can emit radio waves in the vicinity of this device, such as cellular phones, wireless
transceivers, mobile radio transmitters, and radio remote control toys.
Caution: This device may emit RF energy during operation. It may cause RF interference
to other medical, non-medical, and radio communication devices. To effectively prevent
such interference, this product complies with the RF emission limit specified in the Class
A standard of IEC00112 Group 1. However, Hisense does not guarantee that no
interference is generated under separate installation conditions.
Warning: The following cables must be used to meet the requirements of electromagnetic
radiation and electromagnetic immunity:
Cable Name
Power cable (10 A)
Important Safety Precautions
Length
1.5 m
V