Install Track And Arm - Assa Abloy Norton D6011 Series Installation Instructions Manual

D6011/D6051 Double Unit Series (Pull Side) Power Operator

Install Track and Arm

A. Mount Tracks to doors.
1 . Using previously prepared holes
in doors, install three (3) 1/4-20 x
1-5/8" screws through each track and
into sex bolts . (Figure 19)
NOTE: (Figure 20)
• Opening of track is toward top
of door.
• Adjustable bumper stop is toward
hinge edge of door.
B. Install Arm Assemblies To Tracks.
1 . Open door of your choosing .
2 . Using an adjustable wrench, rotate
top pinion 45 degrees toward door
hinge . You will feel resistance from
spring . (Figure 21)
3. While holding pinion at 45 degrees,
slide arm on bottom pinion parallel
to frame as shown . (Figure 21)
NOTE: Pinion flat should be aligned
as shown. (Figure 22)
4 . Secure arm to pinion with 1/4-20 x
1/2" screw and countersunk patch
washer . (Figure 21)
5 . Insert stud on arm into slider in track
by pressing clip on backside of slider
onto stud . (Figure 23)
6 . To adjust track stop:
• Use allen wrench to loosen set
• Open door to full open position .
• Slide bumper stop until it just
• Tighten set screw in bumper stop
7 . Repeat on second door .
Copyright © 2019-2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9360-1029-020 Rev 5 11/20
screw in bumper stop .
touches end of slider .
so bumper will stay in position .
(Figure 24)
Figure 19
Track Opening
Arm Stud
Slide
Assembly
Bumper Stop
Figure 24
Adjustable Bumper Stop
Figure 21
Figure 22
A
B
Figure 23
Set Screw
Figure 20
11