Install Track And Arm - Assa Abloy NORTON RIXSON D6051 Series Installation Instructions Manual

D6011/D6051 Series Double Unit Pull Side Power Operator

Install Track and Arm

A. Mount Tracks to doors.
1. Using previously prepared holes in doors,
install three (3) 1/4-20 x 1-5/8" screws through
each track and into sex bolts. (Figure 20)
NOTES: (Figure 21)
y Opening of track is toward top
of door.
y Adjustable bumper stop is toward hinge
edge of door.
B. Install Arm Assemblies To Tracks.
1. Open door of your choosing.
2. Using an adjustable wrench, rotate top
pinion 45 degrees toward door hinge. You
will feel resistance from spring. (Figure 22)
3. While holding pinion at 45 degrees, slide
arm on bottom pinion parallel to frame as
shown. (Figure 22)
NOTE: Pinion flat should be aligned as
shown. (Figure 23)
4. Secure arm to pinion with 1/4-20 x 1/2" screw
and countersunk patch washer. (Figure 22)
5. Insert stud on arm into slider in track by
pressing clip on backside of slider onto stud.
(Figure 24)
6. To adjust track stop:
y Use allen wrench to loosen set screw in
bumper stop.
y Open door to full open position.
y Slide bumper stop until it just touches
end of slider.
y Tighten set screw in bumper stop so
bumper will stay in position.(Figure 25)
7. Repeat on second door.
Bumper Stop
Figure 25
Copyright © 2019, 2020, 2023, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9360-1029-020 Rev 6 01/23
Set Screw
Approved 2023-01-24
Figure 20
Track Opening
Arm Stud
Slide
Assembly
Adjustable Bumper Stop
Figure 22
Figure 23
A
B
Figure 24
Figure 21
11