Table of Contents
Advertisement
Install Adjusting Tube and Shoe and Main Arm
A. Mount Adjusting Tube and Shoe to door.
1. Using previously prepared holes in door,
install two (2) 1/4-20 x 1-5/8" screws through
shoe and into sex bolts. (Figure 19)
NOTE: Orient shoe with short side of shoe
toward hinge. (Figure 20)
B. Install Main Arm.
1. With door open, slide main arm rod into
adjusting tube. (Figure 21)
2. Place square of main arm onto closer pinion.
(Figure 21)
NOTE: Pinion flat should be aligned as
shown. (Figure 22)
3. Attach main arm to pinion with screw then
tighten with 7/16" wrench. (Figure 21)
4. With door closed, rotate main arm
away from hinge until adjusting tube is
perpendicular (90 degrees) with door.
(Figure 23)
5. While holding arm in position, secure rod to
adjusting tube with forearm screw.
(Figure 24)
10
6021/6031 Series (Push Side) Power Operator
Arm Marking
Pinion Flat
Figure 22
Figure 23
Copyright © 2019, 2023, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
Approved 2023-01-24
Figure 19
Hinge
Short Side
of Shoe
Figure 20
View from ceiling looking downward
View from ceiling looking downward
Figure 21
Figure 24
80-9360-1027-020 Rev 5 01/23
Advertisement
Table of Contents
