Installing The Dynamicaccess Lan Agent - 3Com 3C905C-TX-M User Manual

86 A
PPENDIX
Operating
System
Windows 95
Windows 98
Windows NT 4.0
Windows NT 3.51 Pentium/100 MHz CPU

Installing the DynamicAccess LAN Agent

To install the DynamicAccess LAN agent:
1 Make sure that the NIC and the network driver are
installed on your PC.
See
confirm that the NIC is properly installed in the PC.
2 Start Windows.
3 Insert the EtherCD in the CD-ROM drive.
The EtherCD Welcome screen appears.
If the EtherCD Welcome screen does not appear, enter
the following command from Run option of the
Windows Start menu:
d:\installs\setup.exe
where d:\ represents the letter name of the CD-ROM drive.
4 Click NIC Software.
5 Click DynamicAccess Technologies.
6 Click DynamicAccess LAN Agent.
B: I D
NSTALLING THE
PC Requirements
486/75 MHz CPU
16 MB RAM (32 MB recommended)
5 MB available hard drive space
486/75 MHz CPU
16 MB RAM (32 MB recommended)
5 MB available hard drive space
Pentium/100 MHz CPU
32 MB RAM
5 MB available hard drive space
32 MB RAM
5 MB available hard drive space
"Verifying Successful Installation"
Access LAN A
YNAMIC GENT
Recommended
Microsoft Service Pack
Windows 95 OSR2 or
Service Pack 1
None
Service Pack 3
Service Pack 5
in Chapter 3 to