Intelligent Auto Install Requirements; Running The Intelligent Auto Install Software - 3Com 3C905C-TX-M User Manual

50 C
HAPTER

Intelligent Auto Install Requirements

To use the intelligent auto install program:

Running the Intelligent Auto Install Software

To run the intelligent auto install software to install the
client software and drivers for a NetWare network:
1 Install the NIC and connect it to the network, as
described in Chapter 2.
2 Reboot to DOS.
3 Insert the EtherCD in the CD-ROM drive.
4 At the DOS prompt, enter the following command,
where d is the drive letter of your CD-ROM drive:
d:install
The main menu appears.
5 Select Auto Install and Config for NetWare and
press Enter.
6 Select DOS, Windows 3.1x, or Windows for
Workgroups 3.11, and follow the instructions.
7 When the installation process is finished, remove the
EtherCD and reboot the PC.
If you are running Windows 3.1x, after you connect to
the NetWare server, run the WSINSTALL program for full
Windows support. Contact your system administrator for
the location of this NetWare utility.
4: I N
NSTALLING THE
Make sure that your PC has only one EtherLink PCI
NIC installed.
Make sure that you are using NetWare 3.x, 4.x, or 5.x as
your network operating system.
Make sure that your PC has at least 1 MB of available
hard drive space.
W C
ET ARE LIENT AND
S D
ERVER RIVERS