Error Massage; Operating Key - ADTEK MW-5 Operating Manual

Error Masage
■
BEFORE POWER ON, PLEASE CHECK THE SPECIFICATION AND CONNECTION AGAIN.
SELF-DIAGNOSIS AND ERROR CODE:
DISPLAY
Display is positive-overflow (Signal is over
ovfl
display range)
Display is negative-overflow (Signal is under
-ovfl
display range)
ADC is positive-overflow (Signal is higher than
ovfl
input 120%)
ADC is negative-overflow (Signal is lower than
-ovfl
input -120%)
EEPROM occurs error
eep fail
aiCng pv Calibrating Input Signal do not process
aic fail Calibrating Input Signal error
aoCng pv Calibrating Output Signal do not process
aoc fail Calibrating Output Signal error

Operating Key:

■
*Please access to the Engineer Level to check and set the parameters when users start to run the meter

Operating Key: 4 keys for

The meter has desgined operation similar as PC's
"enter" or "confirm setting", and press key means "escape(

In Engineer Level, the screen will return to Measuring Page after do not press any key over 2 minutes, or
press for 1 second.
(1) In any page, press
(= )
the level or function index
Enter/Fun key
(2) From the function index to
access setting status
(= ) (1) In measuring page, press
for 1 second to access user
Shift key
level.
(2) In function index, press
second to go back upper level.
(3) In function group index, press
measuring page
(1) In function index, press
(= )
go back to previous function
Up key
index
(1) In Function Index Page, press
(= )
Down key
Index Page.
DESCRIPTION
Enter(Function) /
Function Index
to access
for 1 second to go back
will go to the next Function
MW-5 Operating Manual 2012-07-19
(Please check the input signal)
(Please check the input signal)
(Please check the input signal)
(Please check the input signal)
(Please send back to manufactory for
repaired)
(Please process Calibrating Input
Signal)
(Please check Calibrating Input Signal)
(Please process Calibrating Output
Signal)
(Please check Calibrating Output Signal)
Shift(Escape) / Up key /
and
Enter
)" or "shift".
Esc
(3) Setting Confirmed, save to EEProm and go to next
function index
(4) In seting status, press
position.
(5) In seting status, press
for 1 setting and go back this function index.
to (2) In setting status for function, press
function
(3) During number Setting, press
up
(2) In setting status for function, press
function
(3) During number Setting, press
down.
REMARK
Down key
. In any page, press
Setting Status
to Shift the setting
for 1 second to abort
can roll the digit
can roll the digit
key means
to select
to select
11 / 36