Continuous Mode - JAI AD-131GE User Manual

3) 1 frame is output
4) AcquisitionActive becomes ―FALSE‖ (stop capturing)
ExposureActive
FrameActive
CCD Readout
Stream
Active
AcquisitionStatus
This drawing shows a case where the trigger is ―OFF‖. If the trigger is ON, FrameActive
becomes ―TRUE‖ on the different timing of AcquisitionActive.
◆ Forcing acquisition to stop
While AcquisitionActive is ―TRUE‖, if AcquisitionEnd or AcquisitionAbort is
initiated, AcquisitionActive becomes ―FALSE‖ (stop capturing).
10.1.2.2

Continuous mode

In this mode, when the AcquisitionStart command is set, the image is continuously output at
the current frame rate. This is the default setting for the AD-131GE.
1) AcquisitionStart command is input
2) AcquisitionTriggerWait becomes effective
3) AcquisitionActive becomes "TRUE"
4) Images begin outputting continuously
5) AcquisitionEnd command is sent
6) AcquisitionActive becomes "FALSE". At this moment, the output stops.
This drawing shows a case where the trigger is ―ON‖. If the trigger is OFF,
FrameActive becomes ―TRUE‖ at the same timing as AcquisitionActive.
AD-131GE
AcquisitionStart
Acquisition
Acquisition
Trigger
Wait
Fig.32
ExposureActive
FrameActive
CCD Readout
Stream Active
AcquisitionStart
Acquisition
Trigger
AcquisitionStatus
Wait
Fig.33
AcquisitionTriggerWait
Active
Single frame timing
Frame 1
AcquisitionActive
Continuous timing
45
Frame N
AcquisitionStop
Acquisition
Trigger
Wait