Continuous Mode; Trigger Operation With Pre-Select Exposure Time (Eps) - JAI AD-131GE User Manual

10.6.2

Continuous mode

For applications not requiring asynchronous external triggering, this mode should be used for
continuous operation. The frame rate is 31fps. If partial scanning is applied, the frame rate will
be faster.
As for the details of timing, refer to section 8.4 Video timing. In this mode, the exposure is
controlled by the electronic shutter.
The following is an example of the settings.
To use this mode
Set function:
10.6.3

Trigger operation with pre-select exposure time (EPS)

An external trigger pulse initiates the capture, and the exposure time (accumulation time) is
the fixed shutter speed set by registers. The exposure time can be set from 0L to 982L in 1 LVAL
steps. The accumulation can be LVAL synchronous or LVAL asynchronous. The resulting video
signal will start to be read out after the selected shutter time. For the details of timing, refer
to section 8.4 Video timing and fig. 40 to fig.43.
To use this mode:
Set function:
Input:
This function can be set by selecting Edge pre-select in Exposure mode of JAI Acquisition Control.
However, Acquisition Mode, Sync Mode, Exposure Time, and so on should be set.
AD-131GE
Acquisition mode
Trigger mode
Sync mode
Exposure Mode
Pixel Format
Other functions
Acquisition mode
Trigger mode
Sync mode
Exposure Mode
Exposure time
Other functions
External Trigger
：Continuous
：OFF
：Refer to 10.5.4
：Timed
：8bit、10bit、12bit
：Frame Start
：ON
：Refer to 10.5.4
：Timed
：Exposure time/Exposure time(us)/
Exposure time(Raw)
Trigger Source
54