Acquisition Mode; Single Frame - JAI AD-131GE User Manual

Exposure mode
The flow of these commands is shown below.
The following drawings are based on the conditions that the Acquisition mode is Single
and the Trigger selector is Frame Start.
If the acquisition start is set at ON (The acquisition is controlled externally)
Acquisition
Start
Command
Executed
Acquisition
Status
If the acquisition start is set at OFF (The acquisition is controlled internally)
Acquisition
Start
Command
Executed
Acquisition
Status
The following sections provide the details for each command set.
10.1.2

Acquisition mode

The AD-131GE has three settings for capturing images.
 Single frame
AcquisitionStart command outputs one frame. Then the acquisition is stopped.
 Continuous
AcquisitionStart command outputs frames until AcquisitionEnd is initiated.
10.1.2.1

Single Frame

In single frame mode, executing the AcquisitionStart command causes one frame to be
captured. After one frame is captured, this operation is automatically stopped.
In order to restart the capture, it is necessary to input the AcquisitionStart command again.
BlockID is not reset until AcquisitionEnd is input and is incremented when the AcquisitionStart
command is called.
◆ Normal single frame operation
1) AcquisitionStart command is input
2) AcquisitionActive becomes ―TRUE‖ (accepts capture)
AD-131GE
To set the exposure method
Acquisition
Start
Trigger
Acquisition Frame Start
Trigger Wait Trigger Wait
Frame Start
Trigger Wait
Frame Start
Trigger
Acquisition Active
Frame Start
Trigger
Acquisition Active
44
Acquisition
Start
Trigger
Acquisition
Trigger Wait
Frame Start
Trigger
Frame Start
Trigger Wait