Table of Contents
Advertisement
DRAINING FUEL SYSTEM
1.
Move unit to an open, well-ventilated area with no
flames or sparks.
2.
Remove fuel tank cap and siphon fuel into a clean
gasoline container.
3.
Reinstall fuel tank cap and tighten.
4.
Start engine to burn remaining fuel in fuel system and
leave engine running until it "runs dry" and stops.
Refer to Operator's Manual for engine start procedure.
5.
Turn engine switch to OFF position and close fuel
valve.
SEPARATE BRUSH FROM FRAME
NOTICE: Save all hardware for reinstallation.
1.
Move unit to a flat, level surface.
2.
Turn engine switch to OFF position and wait for all
moving parts to stop and for hot parts to cool.
3.
Disconnect spark plug wire from engine.
4.
Remove tapping screw securing left side of belt cover
to frame.
5.
Loosen, but DO NOT remove tapping screw securing
right side of belt cover to frame and remove belt cover
Figure 2
See Figure 3.
6.
Remove hardware retaining belt finger to engine and
remove belt finger.
WARNING: AVOID INJURY. Engine sheave
edges are sharp. Wear thick gloves to remove
belts from engine sheave.
7.
Remove attachment drive belts from engine sheave.
NOTICE: To assist belt removal, slowly pull recoil starter
handle while gently pulling belts from engine sheave.
8.
Remove brush lock cable from J-clamp on engine
mount. See Figure 4.
EN – 7
Figure 3
Figure 4
Advertisement
Table of Contents
