Table of Contents
Advertisement
6.
Remove hardware securing brush core to center shaft.
See Figure 44.
7.
Remove hardware securing center shaft bearings to
attachment frame. See Figure 45.
8.
Remove attachment frame from brush assembly and
rotate frame onto mounting bracket. See Figure 46.
Figure 44
Figure 45
Figure 46
See Figure 47.
9.
Loosen bearing set screws.
10. Loosen, but DO NOT remove hardware retaining
support bearings to mounting bracket.
1
1. Set Screw
11. Remove U-joint assembly. See Figure 48.
EN – 21
Figure 47
Figure 48
Advertisement
Table of Contents
