Table of Contents
Advertisement
5.
Remove hardware securing center shaft bearings to
attachment frame. See Figure 29.
6.
Push handlebars down to disengage attachment
frame from brush assembly. See Figure 30.
7.
Move tractor away from brush assembly and slowly
lower tractor so it rests on attachment frame.
Figure 29
Figure 30
See Figure 31.
8.
Loosen set screws on center shaft bearings and
remove bearings from shaft ends.
1. Bearing
2. Set Screw
9.
Remove brush core from center shaft. See Figure 32.
10. Position brush core vertical, remove hardware
retaining end plate and remove end plate. See
Figure 33.
EN – 17
2
Figure 31
Figure 32
1
Advertisement
Table of Contents
