Table of Contents
Advertisement
FRICTION DISC REPLACEMENT
Remove Friction Disc
NOTICE: Save all hardware for reinstallation.
WARNING: AVOID INJURY. Before rotating unit
forward, drain fuel from tank and fuel system.
See Draining Fuel System on page 7. Make sure
unit is secure and will not tip.
1.
Turn engine switch to OFF position and wait for all
moving parts to stop and for hot parts to cool.
2.
Disconnect spark plug wire from engine.
3.
Separate brush from frame and remove bottom cover.
See Separate Brush From Frame on page 7 and
Bottom Cover Removal on page 9.
4.
Position support under frame and engine sheave so
wheels are off the ground. Make sure unit is secure
and will not tip.
5.
Remove snap clips from axle ends and remove
wheels.
See Figure 14.
6.
Remove hairpin securing adjustment pivot pin to
speed selector arm and remove adjustment pivot pin.
See Figure 15.
7.
Remove two spring clips from hex shaft.
8.
Remove hardware securing bearing flange to frame
and remove bearing flange.
Figure 14
4
3
1. Spring Clip
2. Hex Shaft
3. Tapping Screw
4. Bearing Flange
See Figure 16.
9.
Remove hex shaft from friction disc and remove
friction disc from shift fork.
NOTICE: Lower flat steel washer on friction disc drive
carrier will fall from drive carrier when removed from shift
fork.
1. Friction Disc
2. Shift Fork
3. Flat Steel Washer
EN – 12
2
1
Figure 15
1
Figure 16
2
3
Advertisement
Table of Contents
