Install Traction Drive Clutch Cable - Ariens 926062 Service Manual

Install Traction Drive Clutch Cable

WARNING: AVOID INJURY. Before rotating unit
forward, drain fuel from tank and fuel system.
See Draining Fuel System on page 7. Make sure
unit is secure and will not tip.
1. Remove bottom cover. See Bottom Cover Removal on
page 9.
See Figure 81.
2. Route cable end with spring hook through hole in back
cover.
3. Install cable end onto swing gate.
Figure 81
See Figure 82.
4. Align cable with cable pulley and tighten shoulder bolt.
5. Reconnect lower traction clutch cable to upper traction
clutch cable.
1. Upper Traction Clutch Cable
2. Lower Traction Clutch Cable
3. Cable Pulley
4. Shoulder Bolt
6. Reinstall bottom cover.
7. Return tractor to upright position and support
handlebars. Make sure tractor is secure and will not
tip.
8. Reinstall brush attachment. See Install Brush to
Frame on page 8.
9. Reinstall upper traction clutch cable to traction clutch
lever. Secure with one flat steel washer and hairpin.
See Figure 78.
10. Adjust traction drive clutch. Refer to Operator's
Manual for adjustment procedure.
11. Fill fuel tank and reconnect spark plug wire.
IMPORTANT: Check all adjustments after first use.
EN – 34
1
2
4
3
Figure 82