Table of Contents
Advertisement
DIFFERENTIAL GEAR REPLACEMENT
Remove Differential Gear
NOTICE: Save all hardware for reinstallation.
WARNING: AVOID INJURY. Before rotating unit
forward, drain fuel from tank and fuel system.
See Draining Fuel System on page 7. Make sure
unit is secure and will not tip.
1.
Turn engine switch to OFF position and wait for all
moving parts to stop and for hot parts to cool.
2.
Disconnect spark plug wire from engine.
3.
Separate brush from frame and remove bottom cover.
See Separate Brush From Frame on page 7 and
Bottom Cover Removal on page 9.
4.
Position support under frame so wheels are off the
ground. Make sure unit is secure and will not tip.
5.
Remove snap clips from axle ends and remove
wheels.
See Figure 63.
6.
Remove E-ring from right axle end.
7.
Hold differential gear in place and remove long axle
from differential.
Figure 63
See Figure 64.
NOTICE: Two flat steel washers will become free when
short axle is removed.
8.
Hold differential gear and remove short axle.
IMPORTANT: Make sure two sleeve bushings remain
inside short axle ends.
2
1
1. Sleeve Bushing
2. Flat Steel Washers
EN – 27
Figure 64
1
Advertisement
Table of Contents
