Install Swing Gate Assembly - Ariens 926062 Service Manual

WARNING: AVOID INJURY. Wear thick gloves;
traction drive pulley and engine sheave edges
are sharp.
8. Remove swing gate assembly. See Figure 23.

Install Swing Gate Assembly

WARNING: AVOID INJURY. Wear thick gloves;
traction drive pulley and engine sheave edges
are sharp.
1. Position swing gate assembly inside frame and align
with pivot rod holes.
Figure 23
2. Reinstall pivot rod through swing gate and secure with
one flat steel washer and three hairpins. See
Figure 24.
3. Reconnect traction drive clutch cable and return
spring to swing gate. See Figure 25.
NOTICE: If traction drive clutch cable was removed from
traction clutch lever, reinstall cable to lever. See Figure 78.
4. Reinstall traction belt. See Install Traction Drive Belt
on page 11.
5. Reinstall brush attachment. See Install Brush to
Frame on page 8.
6. Adjust traction drive clutch. Refer to Operator's
Manual for adjustment procedure.
7. Reconnect spark plug wire.
IMPORTANT: Check all adjustments after first use.
EN – 15
Figure 24
Figure 25