LogTag Recorders UTREL30-WiFi Product User Manual page 17

Preparing a UTREL30-WiFi for first use
The logger is unconfigured
An unconfigured UTREL30-WiFi logger is delivered to you hibernated (i.e. in a state of low
power consumption), and pressing the
If your logger is unconfigured you must set it up with the parameters required for
starting and recording temperature values;
l
printing the PDF;
l
connecting to the local WiFi network;
l
connecting to your LogTag
l
triggering alarms.
l
This is done using LogTag
analyzing data. LogTag
will allow you to set wireless and network settings and register the UTREL30-WiFi against
®
your LogTag Online account.
Start the LogTag
l
Remove the protective cap from the logger's USB socket and plug the Micro USB end
l
of the cable into the socket. Plug the other end of the cable into a USB socket on your
computer and wait for the drivers to be installed
1
You can configure more than one UTREL30-WiFi at the same time, however it is practical to limit the number of units to about
6, using a powered USB hub.
UTREL30-WiFi User Guide
REVIEW
and then
®
Online cloud account; and
®
Analyzer software, which can also be used for downloading and
®
Analyzer includes the LogTag
®
Analyzer software.
shows:
/MARK
®
Online Connection Wizard, which
1
.
17