StarTech.com ARMSLIMDUAL2USB3 User Manual page 33

Using the 4 mm Hex Key tighten the Countersunk Hex
3.
Screws, being careful not to over-tighten.
Remove the backing from the Adhesive Foam Pad.
4.
Carefully apply the Adhesive Foam Pad to the bottom side
5.
of the Base Plate.
Note: The hole in the Adhesive Foam Pad should be closest
to the rear edge of the Base.
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Removing the Adhesive Backing
Applying the Adhesive Foam Pad
32