Status Indications According To Auma Classification - AUMA SAEx 07.2 Operation Instructions Manual

Indications
7.2.2.

Status indications according to AUMA classification

40
SAEx 07.2 SAEx 16.2 / SAREx 07.2
Figure 44: Status indication for multiport valve (example P4 = 180°)
P (P1, P2, ...) selected position (1, 2, ...)
( ) no position selected
E2 Actual position value
These indications are available, if the parameter Diagnostic classific. M0539 is set
to AUMA.
Warnings (S0005)
If a warning has occurred, the display shows S0005:
the number of warnings occurred
a blinking question mark after approx. 3 seconds
Figure 45: Warnings
For further information, please also refer to <Corrective action>.
Not ready REMOTE (S0006)
The S0006 display shows indications of the Not ready REMOTE group.
If such an indication has occurred, the display shows S0006:
the number of indications occurred
a blinking crossbar after approx. 3 seconds
Figure 46: Not ready REMOTE indications
For further information, please also refer to <Corrective action>.
Fault (S0007)
If a fault has occurred, the display shows S0007:
the number of faults occurred
a blinking exclamation mark after approx. 3 seconds
SAREx 16.2 Control unit: electronic (MWG)
ACExC 01.2 Non-Intrusive