SAEx 07.2
SAEx 16.2 / SAREx 07.2
ACExC 01.2 Non-Intrusive
Information
6.3.
Menu navigation via push buttons (for settings and indications)
Backlight
SAREx 16.2 Control unit: electronic (MWG)
For actuators equipped with a positioner, it is possible to change over between OPEN
- CLOSE control (Remote OPEN-CLOSE) and setpoint control (Remote SET-
POINT). Selection is made via MODE input, e.g. based on a 24 V DC signal (refer
to wiring diagram).
Menu navigation for display and setting is made via the push buttons [1
local controls.
Set the selector switch [5] to position 0 (OFF) when navigating through the menu.
The bottom row of the display [6] serves as navigation support and explains which
push buttons [1
4] are used for menu navigation.
Figure 25:
[1 4] Push buttons or navigation support
[5]
Selector switch
[6]
Display
Table 9: Important push button functions for menu navigation
Push buttons
Navigation sup-
port on display
Up ▲
[1]
Down ▼
[2]
Ok
[3]
Save
Edit
Details
[4] C
Setup
Esc
The display is illuminated in white during normal operation. The backlight turns
to red under fault conditions.
The screen illumination is brighter when operating a push button. If no push
button is operated for 60 seconds, the display will become dim again.
Functions
Change screen/selection
Change values
Enter figures from 0 to 9
Change screen/selection
Change values
Enter figures from 0 to 9
Confirm selection
Save
Enter <Edit> menu
Display more details
Enter Main menu
Cancel process
Return to previous display
Operation
4] of the
31