Tools Required; Screwing The Transport Units Together - Siemens SINAMICS PERFECT HARMONY GH150 6SL3826 Operating Instructions Manual

Assembly

5.3 Screwing the transport units together

Damage caused by foreign bodies
If foreign bodies are left in the device after installation and maintenance work, this can cause
damage when the device is switched on.
● Before switching on, check as to whether there are any foreign bodies in the device.
Damage caused by incorrectly opening the doors
You can damage the locking mechanism if you open the doors incorrectly.
● Open the doors as described in Section "Preparing for use".
See also
Opening the device (Page 93)
5.2

Tools required

You require the following tools for mounting and installation:
● Wrench or socket wrench, width across the flats 10, 13, 16/17, 18/19
● Allen key, size 8
● Torque wrench up to 50 Nm
● Screwdriver, size 2
5.3 Screwing the transport units together
NOTICE
Material damage caused by mechanical pressure on components
Stress that occurs during transport may exert mechanical pressure on the components.
Material damage can result.
● Line the cabinets up precisely with each other in order to avoid shearing forces when the
● Install the converter only on a level and horizontal surface.
Preparation
Ensure that access to the holes in the bottom of the cabinets is unobstructed. Remove the
guard covers.
68
Remove any foreign bodies.
base units are screwed together.
SINAMICS PERFECT HARMONY GH150 6SL3826
Operating Instructions 05/2020