Table of Contents
Advertisement
Installation
5.4 Screwing the transport units together
5.2
Tools required
You require the following tools for mounting and installation:
● Wrench or socket wrench, width across the flats 10, 13, 16/17, 18/19
● Allen key, size 8
● Torque wrench up to 50 Nm
● Screwdriver, size 2
● Torx T20 and T30 screwdrivers
5.3
Removing transport rails
Support rails for crane transportation are attached to the bottom of the cabinet.
To remove the rails, remove the fixing screws
Figure 5-1
5.4
Screwing the transport units together
NOTICE
Material damage caused by mechanical pressure on components
Stress that occurs during transport may exert mechanical pressure on the components.
Material damage can result.
● Line the cabinets up precisely with each other in order to avoid shearing forces when the
● Install the converter only on a level and horizontal surface.
72
Removing the support rails
base units are screwed together.
①
with an M12 spanner.
SINAMICS GM150 6SL3810-2LN31-8AA2
Operating Instructions Rev.201910281332 EXAMPLE
Advertisement
Table of Contents
