Installation
5.10 Removing the dust protection cover
①
②
③
④
Pos. 10
Pos. 20
Pos. 30
Pos. 40
Pos. 50
Pos. 60
Figure 5-7
1. Pull off the expanding rivets
2. Loosen the Torx screws
3. Pinch off what remains of the cable ties
4. Loosen the screws
5. Remove the Makrolon plates one after the other in the following order:
98
Expanding rivets
M8 screw, washer, M8 nut
Torx screws, size T30
Cable ties
Makrolon plate, connecting part left
Makrolon plate, connecting part right
Makrolon plate, rear right
Makrolon plate, pipe, on the top right
Makrolon plate, pipe, on the bottom right
Makrolon plate, center front
Dust protection cover, rectifier
②
"Pos. 30"
"Pos. 60"
"Pos. 50",
"Pos. 40"
"Pos. 20"
"Pos. 10"
①
using flat-nose pliers.
③
.
④
with the side cutter and remove them.
with the wrench and remove them.
SINAMICS SM150 6SL3815-7NP41-0AA1
Operating Instructions Rev.201910281301 EXAMPLE