Siruba 700QD Instruction Book page 73

LED 顯示
無工件調整:
已經完成設定，但是有
時候無法穩定入光、遮
光。光量過大。
Adjust without work
pieces:
Finish the setting but the
light or obscuring is not
stable, or the amount of
light is too high.
無工件調整:
兩邊持續緩慢閃爍
已經完成設定，但是有
(約1Hz)Both lights
時候無法穩定入光、遮
光。光量過大。
keep flashing
Adjust without work
slowing
pieces:
(about 1Hz)
Finish the setting but the
light or obscuring is not
stable, or the amount of
light is too high.
2點調整:
已經完成設定，但是有
時候無法穩定入光、遮
光。
2點的光量差過小。
2 Point Adjustment:
Finish the setting but the
light or obscuring is not
stable.
The light amount
difference between is
too low.
6. 後電眼 調 整 方 式：
1.自 動設 定 ：
步驟1:電 眼中 間 保持 淨 空， 在 參數29的
設定 層 裡 按 住 左鍵 直 到LED顯 示scan 後
即可 放 開.， 此 時後 電 眼進行 無布料 自 動
調 整 動 作 ， 當LED顯 示press即 代表 完成
無布 料 調 整 。
狀態 State
按一下按鈕的話，會依照微調結果，回復通
常作動。請以檢測體確認作動。
透過型:
請設法使用狹光片或傾斜光軸等，降低光
量，再度進行調整。
反射型:
請設法將背景及周邊之反射物體塗黑等，降
低反射光量，再度進行調整。
Press the button once to back to the normal
operation based on the inching. Please make
sure the setting.
Transmission
Please reduce the amount of light by the light
filter or tilt optic axis and adjust.
Reflex:
Please reduce the amount of light by
blackening the reflectors around, and adjust.
透過型、鏡片反射型:
按一下按鈕的話，會依照調整結果，回復通
常作動。請調整光軸，再度進行調整。
Transmission, Lens Reflex
Press the button once to back to the normal
operation based on the adjusting. Before the
adjusting, please adjust the optic axis.
透過型、鏡片反射型、反射型
按一下按鈕的話，會依照調整結果，回復通
常作動。請確認作動後使用。
Transmission, Lens Reflex, Reflex
Press the button once to back to the normal
operation based on the adjusting. Please
make sure the setting before using.
表6/Table6
6. Adjustment for rear electric eye:
1.Auto setting:
Step1: Clear the center region of the electric
eye, and then keep pressing the left key on
the setting of the parameter 29, until LED
displays "scan." The electric eye would
auto adjusts without fabric. The adjustment
would finish when LED shows "press."
-55-
Introduction
對應方法 Countermeasure
從遮
Ch
No
green
P67