SNTP Settings
Time Settings
To configure the time settings for the Switch, open the Administration folder. Then the SNTP
Settings folder and click on the Time Settings link, revealing the following window for the user to
configure.
The following parameters can be set or are displayed:
Parameter
System Boot Time
Current Time
Time Source
SNTP State
SNTP Primary Server
SNTP Secondary
Server
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
Figure 6- 14. Current Time: Status window
Description
Displays the time when the Switch was initially started for this session.
Displays the Current Time.
Displays the time source for the system.
Current Time: SNTP Settings
Use this pull-down menu to Enabled or Disabled SNTP.
This is the IP address of the primary server the SNTP information will be taken from.
This is the IP address of the secondary server the SNTP information will be taken
from.
Current Time: Status
47