D-Link xStack DES-3800 Series User Manual page 80

To add a new entry to the Switch's SNMP Host Table, click the Add button in the upper left-hand
corner of the window. This will open the SNMP Host Table Configuration window, as shown
below.
The following parameters can set:
Parameter
Host IP Address
SNMP Version
Community String or
SNMP V3 User Name
To implement your new settings, click Apply. To return to the SNMP Host Table, click the
SNMP Host Table Entries
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
Figure 6- 29. SNMP Host Table window
Figure 6- 30. SNMP Host Table Configuration window
Description
Type the IP address of the remote management station that will serve as the SNMP
host for the Switch.
V1 - To specifies that SNMP version 1 will be used.
V2 - To specify that SNMP version 2 will be used.
V3-NoAuth-NoPriv - To specify that the SNMP version 3 will be used, with a
NoAuth-NoPriv security level.
V3-Auth-NoPriv - To specify that the SNMP version 3 will be used, with an Auth-
NoPriv security level.
V3-Auth-Priv - To specify that the SNMP version 3 will be used, with an Auth-Priv
security level.
Type in the community string or SNMP V3 user name as appropriate.
link.
64
Show All